Your Brekr F250 has three saddle height options: low, mid and high. Follow the steps below to adjust the saddle to your desired height.
- Use the Torx20 key to unscrew the covers for the saddle height adjustment on both the left and right rear sides. Remove these covers from the frame.
- Use the Torx30 key to loosen the two bolts at the left rear and the two bolts at the right rear. Then, with the Torx30 key, loosen the screw at the front of the frame. This screw does not need to be fully removed and can remain in the frame.
- Slide the entire saddle horizontally while keeping it leveled, moving it up or down (front and back simultaneously) to the desired position: high, mid, or low. If the saddle is in the correct position, use the Torx30 key to screw in two screws, one in the upper and one in the lower visible hole on each side at the back. Do not fully tighten these screws yet. Then, also screw the bolt at the front of the frame into its designated hole. Afterward, hand-tighten all the bolts.
- Afterward, screw the cover caps back onto both sides of the saddle frame.
